RLIP010 Lavender Oil

Please select from the options above.
Lavender oil (172)
This has a lavender fragrance. It is slow drying and delays the drying process of golds.
Tips for on-glaze painting:
Cadmium reds and yellow:
These warm colours need to be applied more thickly and fired at a
slightly lower temperature, to 790C (maximum), with little or no soak.
This method is most relevant toP4288 Golden Yellow.
Transparent colours:
Any on-glaze or glass paint can be made transparentbythe addition of
clear flux.
Products available from Potterycrafts are:
R5925 - Mixing flux for low sol colours
R5926 - Mixing flux for low sol colours, suitable for use with cadmium
R5625 - Mixing fluxfor leadless colours
R5930 - Mixing flux for glass colours (high temperature)
R5948 - Mixing flux for glass colours (medium temperature)
These fluxes can also be used as a protective layer over on-glaze
decoration to giveextra durability.
Outlines for designs can be traced or drawn free hand using a soft pencil
or finemarker pen. For a more permanent result, a pale brown or grey
on-glaze colour can be used with a finebrush or pen.This can then be
fired to give an outline which will not be lost after the first firing.
Outlinesare best done on ware that has been de-greased with turpentine
and dried.

Matt colours:
On-glazecolours can be matted down with the addition of a matting
agent such as zinc oxide. This should be mixed at approximately two
parts colour to one part matting agent.
Metals and lustres:
When working with any metals or lustres, we recommend you use a
brush dedicated to those products. Do not wash your brush with soap
and water, as this may cause faults on your next application. Rinse used
brushes in the appropriate essence and then wrap the bristle in
aluminium foil. If necessary, soften your brush with essence before
For details of brushes available from Potterycrafts, please refer to our
tools, sponges and brush section.
Potterycrafts on-glaze colours fall into 3 categories
LEADED - (low sol)based on lead frits
LEADLESS - may contain up to 0.5% of lead (usually from the stain
manufacturer), notenough to give lead release
LEADFREE - contains no lead whatsoever
Remember in all cases it is your responsibilityto have the finished ware tested by a competent organisation.

There are no downloads for this product.

There are no reviews for this product yet. Be the first to add one!