Fat Oil - 100ml

Fat oil traditional china painters medium, usually mixed with turps.
Also suitable for underglazes but requireshardening on.
Tips for on-glaze painting:
Cadmium reds and yellow:
These warm colours need tobe applied more thickly and fired at a
slightly lower temperature, to 790C (maximum), with little or no soak.
Thismethod is most relevant to P4288 Golden Yellow.
Transparent colours:
Any on-glaze or glass paint can bemade transparent by the addition of
clear flux.
Products available from Potterycrafts are:
R5925 - Mixingflux for lowsol colours
R5926 - Mixing flux for low sol colours, suitable for use with cadmium
colours
R5625 - Mixing flux for leadless colours
R5930 - Mixing flux for glass colours (high temperature)
R5948 - Mixing flux for glass colours (medium temperature)
These fluxes can also be used as a protective layer over on-glaze
decorationto give extra durability.
Outlines:
Outlines for designs can be traced or drawn free hand using a soft pencil
or fine marker pen. For a more permanent result, a pale brown or grey
on-glaze colour canbeused with a fine brush or pen.This can then be
fired to give an outline which will not be lost after the first firing.

Outlines are best done on ware that has been de-greased with turpentine
and dried.
Mattcolours:
On-glaze colours can be matted down with the addition of a matting
agent such as zinc oxide. This should be mixed at approximately two
parts colour to one part matting agent.
Metals and lustres:
When working withany metals or lustres, we recommend you use a
brush dedicated to those products. Do not wash yourbrush with soap
and water, as this may cause faults on your next application. Rinse used
brushes in the appropriateessence and then wrap the bristle in
aluminium foil. If necessary, soften your brush with essence before
working
.
For detailsof brushes available from Potterycrafts, please refer to our
tools, sponges and brush section.
ON-GLAZE COLOURS AVAILABLE FROM POTTERYCRAFTS
Potterycrafts on-glaze colours fall into 3 categories
LEADED - (low sol) based on lead frits
LEADLESS - may contain up to 0.5% of lead (usually from the stain
manufacturer), not enough to give lead release
LEADFREE - contains no lead whatsoever
Remember in all cases itis your responsibility to have the finished ware tested by a competent organisation.